The position of your graphics on Inkscape canvas is irrelevant. This is one of the reasons why a generic Gcode file may not work. The origin (X=0,Y=0) could be in the centre or top-left of the maximum engraving range depending on the model. This extension warns if the target graphics are larger than allowed engraving range, and you should scale it down and try again. It is noted in the dropdown list of the entension for your reference. Maximum engraving range depends on the model of your LP. (0=off, which makes the Gcode useless, so I disallowed it.) Laser power can be set from 1 (min) to 255 (max).I tested speeds from 0.01mm/min to 70mm/min and they all came out the same on the engraver end. The lowest laser speed is limited to 70mm/min, as this is the lowest effective speed that LaserPecker App allows.Faster or slower than the engraver's top speed does not matter much.Laser head idle movement speed is hard-coded to 6000mm/min. Restart Inkscape and you should be able to access the extension from Extensions > LaserPecker > Gcode Generator for L1/Pro/L2. ![]()
0 Comments
Leave a Reply. |